HDZERO AIO5 WHOOP FLIGHT CONTROLLER - HD VTX - ESC - ELRS 2.4GHZ RX
HDZero AIO5 is the world’s first digital video AIO, enabling bind and fly 65mm whoops to weigh less than19.5g.
AIO5 integrates a F4 flight controller, HDZero 5.8GHz digital video transmitter, SPI 2.4GHz
ExpressLRS 3.0 receiver, DSHOT protocol 4-in-1 ESC, and a 5V/1A BEC. It is ideal for tiny whoop racing and freestyle.
The HDZero AIO5 is an excellent collaboration between Happymodel and HDZero.
For Installation and Setup instructions please check the Setup Manual here
SPECIFICATIONS
- MCU: STM32F411 (100MHz, 512K Flash)
- Gyro: BMI270
- On board voltage and amperage meters
- Built-in 5A(each) BLHeli_S 4-in-1 ESC
- MCU: EFM8BB21
- HV Current: 5A continuous peak 6A (3 seconds)
- Factory firmware: O_H_5_48_V0.19.2.HEX
- Dshot600 ready
- Built-in 5.8G HDZero VTX
- RF output: 25mw/200mW
- Supported channels: R1-R8, F2/F4, L1-L8
- UFL connector (ultra-lite linear antenna included)
- Built-in SPI ExpressLRS 2.4GHz receiver
- Packet rate option: 25Hz/50Hz/150Hz/250Hz/500Hz
- Pre-soldered enamel wire antenna
- Telemetry output power: <12dBm
- Built-in 5V 1A BEC
- Flight controller firmware target: CRAZYBEEF4SX1280, configuration file??
- Power supply: 1S battery (2.5V – 4.35V)
- Fully compatible with the popular whoop frames
- Board size:28.5x28.5mm with a 25.5x25.5 mounting hole size
- Weight: 5.7g(without motor plugs), 6.3g (with motor plugs)
PACKAGE CONTENTS
- 1 x HDZero AIO5 board
- 1 x Power cable with inverted angle A30 connector
- 4 x screws
- 4 x rubber grommets
- 1 x ultra-lite linear VTX antenna
- 1 x Flight controller
- Amps:
- 5
- Mounting:
- AIO
- CPU:
- F4
- Receiver Type:
- ExpressLRS