HDZERO AIO5 WHOOP FLIGHT CONTROLLER - HD VTX - ESC - ELRS 2.4GHZ RX

HDZero AIO5 is the world’s first digital video AIO, enabling bind and fly 65mm whoops to weigh less than19.5g.

AIO5 integrates a F4 flight controller, HDZero 5.8GHz digital video transmitter, SPI 2.4GHz
ExpressLRS 3.0 receiver, DSHOT protocol 4-in-1 ESC, and a 5V/1A BEC. It is ideal for tiny whoop racing and freestyle.

The HDZero AIO5 is an excellent collaboration between Happymodel and HDZero.  

For Installation and Setup instructions please check the Setup Manual here

SPECIFICATIONS

• MCU: STM32F411 (100MHz, 512K Flash)
• Gyro: BMI270
• On board voltage and amperage meters
• Built-in 5A(each) BLHeli_S 4-in-1 ESC
  
  • MCU: EFM8BB21
  • HV Current: 5A continuous peak 6A (3 seconds)
  • Factory firmware: O_H_5_48_V0.19.2.HEX
  • Dshot600 ready
• Built-in 5.8G HDZero VTX
  
  • RF output: 25mw/200mW
  • Supported channels: R1-R8, F2/F4, L1-L8
  • UFL connector (ultra-lite linear antenna included)
• Built-in SPI ExpressLRS 2.4GHz receiver
  
  • Packet rate option: 25Hz/50Hz/150Hz/250Hz/500Hz
  • Pre-soldered enamel wire antenna
  • Telemetry output power: <12dBm
• Built-in 5V 1A BEC
• Flight controller firmware target: CRAZYBEEF4SX1280, configuration file??
• Power supply: 1S battery (2.5V – 4.35V)
• Fully compatible with the popular whoop frames
• Board size:28.5x28.5mm with a 25.5x25.5 mounting hole size
• Weight: 5.7g(without motor plugs), 6.3g (with motor plugs) 

PACKAGE CONTENTS

• 1 x HDZero AIO5 board
• 1 x Power cable with inverted angle A30 connector
• 4 x screws
• 4 x rubber grommets
• 1 x ultra-lite linear VTX antenna

• 1 x Flight controller