Happymodel Mobula6 2024 ELRS 1S Whoop - A30


Happymodel Mobula6 2024 ELRS 1S Whoop - A30

*May differ from pictures shown. 

The Happymodel Mobula6 2024 1S 65mm Ultra Light Micro FPV Whoop comes equipped with a lightweight AIO flight controller and Serial ELRS receiver, as well as a 5.8G OpenVTX for optimal performance. With super light brushless motors, specifically SE0702 weighing only 1.46 grams, this product offers smooth and powerful flight capabilities. The FX17-B 1/3 CMOS 800TVL camera captures awesome footage, making it perfect for those looking for a professional and informative FPV experience. Compatible with both 1S lipo and LIHV batteries. 



  • Brand Name: Happymodel
  • Item Name: Mobula6 2024 1S 65mm ultra light micro FPV Whoop
  • Wheelbase: 65mm
  • Size: 81mm*81mm*37mm
  • Weight: 17.7g


  • Mode: SE0702 KV28000
  • Configu-ration:9N12P
  • Stator Diamter:7mm
  • Stator Length:2mm
  • Shaft Diameter:Φ1mm
  • Motor Dimension(Dia.*Len):Φ9.5mm*14mm
  • Weight(g):1.46g
  • No.of Cells(Lipo):1S only


  • Materials: PC
  • Inch: 31mm
  • Pitch: 0.8 in
  • Weight: 0.21g
  • Mount hole diameter: 1mm

Flight controller

  • SuperX ELRS AIO 5-IN-1 Flight controller
  • MCU:STM32F411CEU6 (100MHZ, 512K FLASH) ,ESP32-PICO-D4
  • Sensor:BMI270(SPI connection)
  • Mount hole size: 25.5mm*25.5mm
  • Power supply: 1S battery input (DC 2.9V-4.35V)
  • Built-in 5A(each) Blheli_S 4in1 ESC
  • Built-in Betaflight OSD(SPI Control)
  • Built-in 5.8G OpenVTX 0mw~400mw (MSP control)
  • Built-in UART ExpressLRS v3.0.0
  • Built-in voltage meter sensor, voltage meter scale 110
  • Built-in current meter sensor, current meter scale 1175

Onboard 4in1 ESC

  • Power supply: 1S LiPo/LiPo HV
  • Current: 5A continuous peak 6A (3 seconds)
  • Support BLHeliSuite programmable
  • Factory firmware: Bluejay v0.19.2
  • Default protocol: DSHOT300
  • Recommend ESC Startup power value to min1100/max1200

Onboard Serial ExpressLRS receiver

  • Packet Rate option: 50Hz/150Hz/250Hz/500Hz
  • ExpressLRS Firmware version: V3.0
  • RF Frequency: 2.4GHz
  • Antenna : Enameled copper wire antenna
  • Telemetry output Power: <12dBm
  • Receiver protocol: Serial_based CRSF
  • Compatible with ExpressLRS V3.x.x TX Module
  • Could flash single ELRS receiver firmware by Wifi
  • ExpressLRS firmware target: Generic ESP32 2.4Ghz RX and VTX

Onboard 5.8g VTX

  • Firmware version: OPENVTX
  • PIT Mode support
  • Channels:40ch
  • Transmitting Power: 0/RCE/25mw/100mw/400mw
  • Power supply: DC 5V
  • Current (5v): <650ma (400mw)
  • Antenna connector: U.FL

FX17-B Camera

  • Model:FX17-B
  • Image Sensor: 1/3″ CMOS
  • Horizontal Resolution: 800TVL
  • FOV 150°
  • Signal System: NTSC
  • Net Weight: 1.5g
  • Dimensions: L14mm*W14mm*H13mm

PACKAGE Contents

  • 1x Mobula6 2024 1S 65mm whoop Drone Frame +Canopy
  • 1x SuperX ELRS AIO 5-IN-1 Flight controller
  • 4x SE0702 KV28000 brushless motor
  • 1x Gemfan 1208-3 31mm tri-blade propellers(4cw+4ccw)
  • 1x FX17-B 1/3 CMOS 800TVL camera NTSC 4:3
  • 1x Onboard 5.8G 25mw~400mw VTX
  • 1x Spare canopy
  • 1x Propeller disassemble tool
  • 1x Screw driver
10.00 (cm)
10.00 (cm)
4.00 (cm)
Receiver Type: