*Only for full DJI systems. If you use Crossfire, you still need to solder. 

FC Specifications

• 2xBMI270 Gyro
• STM32F722   216mhz
• 3-6S direct battery input
• 5V 3A,
• 3V3 100mA
• 9V 2A 18W Design for DJI FPV Air Unit
• 5V Camera Power
• BetaFlight OSD
• 31.5x27 CB with 20x20 mounting holes, weight: 5.85g
• 6 UARTS on board.
• UART1 (Only RX, Air Unit connector)
• UART2 (Free)
• UART3 (Free)
• UART4 (TX and RX connected together for F.Port)
• UART5 (Only RX, ESC Telemetry)
• UART6 (MSP/Configuration Port for Air Unit)
• Built-in 4 IN 1 ESC socket(including ESC telemetry, External current sensor) JST1.0 8Pin
• Plug and plug with NBD  Cricket200 ESC/Infinity200 ESC. Also compatible with most of the ESC on the market.
• Built-in solder pads for ESC signal output and power
• Printed layout instructions ON the board - no need for instructions!
• DJI FPV Air Unit socket (use UART1 and UART6) 

ESC Specifications

• LiPo Power input: 3S-6S
• ESC Programming: BLHeli32
• Cont.Current: 45Ax4
• Burst Current: 55Ax4
• Weight / Size: 13.0g / 39x29.5x8mm
• Mounting holes: 20x20mm
• Signal plug JST1.0 8pin plug with NBD Cricket200FC
• Solder pad ready for signal and power
• Heatsink design
• 8 Layer PCB with 2Oz Copper
• Smoov performance design by Team NBD

Package Contents

• 1x Cricket200 FC F7 flight controller
• 4x Grommets short 4x Grommets Long
• 1x Cricket200 FC to DJI Air module cable 70mm
• 1x Cricket200 4 in 1 ESC BLHeli32 45A
• 4x Short Grommets & 4x Long Grommets
• 5x Steel Screw 25mm
• 13x Nylon Nuts
• 1x Cricket200 FC to Cricket200 ESC cable 30mm
• 1x Cricket200 FC to Cricket200 ESC cable 50mm
• 1x Cricket200 FC to Cricket200 ESC cable 85mm
• 470uf 35v Electrolytic capacitor