null

TBS PodRacer F4 30A AIO Flight Controller

SKU:
TBS-PODRACER-AIO
$90.99

TBS PodRacer F4 30A AIO Flight Controller

TBS partnered with Zeez to make this awesome whoop AIO. Introducing the the TBS Podracer AIO, the board is designed to cater for TBS Pro32 Nano VTX and TBS Crossfire / Tracer Nano RX with direct pin-header installation. The result is a clean, compact and lightweight core for your build..

The FC is equipped with F4+MPU6000 and the ESC is capable of True 30A current running BLHeli32. This board is versatile enough to run on your cinewhoop, 4/5" racer like the podracer and long range cruiser like the TBS Aureo. 

FC Specifications

  • Mounting holes: 25.5×25.5 mm / M2 holes
  • Up to 6S input
  • 5V BEC up to 1.2A continuous
  • STM32F411 MCU (Support BetaFlight, EmuFlight)
  • MPU6000 Gyro/ACC
  • OSD chip Onboard (AT7456E)
  • 2 available UART
  • LC Filter for 5V VTX and Camera
  • Direct solder connection for TBS Nano RX and TBS Unify Pro32 Nano
  • Support programmable LED like WS2812 etc
  • Built-in current sensor

ESC Specifications

  • Signal support: PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600
  • Input voltage: 2S-6S Lipo
  • Continuous current: 30A
  • Peak current: 35A
  • ESC firmware: BLHELI 32
  • PWM Frequency Range: 24KHz up to 96KHz

a7301607.jpg

a7301608.jpg

GPS INSTALLATION

Because of the phyiscal limitations, installing a GPS module to the FC will require a few extra steps to remap the board's resources. 

Note: The following steps will disable LED and FC's SmartAudio and use as softserial for GPS.  

podracer-aio-gps-ss.jpg

        1. Flash the board with Target: STM32F411

                      podracer-aio-gps-target.jpg

        2. Download the Config file [HERE]. Then load it the board. 

        3. Wire the GPS as shown 

                      a73s01607.jpg

Package Contents

  • 1 x TBS Podracer AIO 
  • 1 x Capacitor 
  • 1 x AWG cables set with shrink tubes
  • 4 x mounting grommets
  • 1 x XT60 (Male)
  • 1 x XT30 (Male)
  • 1 x Pinheaders set for TBS VTX and RX
Width:
2.00 (cm)
Height:
1.00 (cm)
Depth:
2.00 (cm)
Amps:
30
Mounting:
AIO
CPU:
F4