null

FPVCycle 13mm Micro Motor 11400KV- T-Mount

SKU:
FPC029

Arriving Soon

FPVCycle 13mm Micro Motor -  T-Mount 

If being used on a TP3 frame or other skinny arm frame, consider reducing ramp up/start up power by a notch or two from default.  Strongly recommend turning on the D notch filter in any flight code you're running.  Consider reducing PID's a bit from default and increasing TPA.  The cross braces for the TP3 arms will allow you to reduce filters and achieve higher tuned control performance if you're searching for it.

Recommended uses

  • 11,400kv 1S with Gemfan 3018 prop at <64g AUW
  • 11,400kv 2S with a ~1.5-2" prop (note 2mm prop shaft)

Checkout the TP3 blog for more details 

Please be careful tightening mounting screws.  These motors are tiny.  You can strip the screw channel if you over tighten them.  Consider some locktite if you're worried.

Specifications

  • ~4.5g with ~40mm wires
  • ~5.6g with ~190mm wires
  • ~42mm wires pre-sized for BabyTooth build
  • Mounting: 9mm diameter, 4 hole, M2
  • 27awg silicone motor wire
  • 2mm press fit prop shaft that’s 5mm tall
  • 2mm internal shaft all the way through
  • T-mount prop mounting also
  • 5mm size bearings
  • C-clip bell bottom and no C-clip on top
  • 0.15mm laminations
  • 7075 aluminum
  • Single piece bell

Recommended use

  • Low load 3” prop: Gemfan 3018 highly recommended
  • Recommended all up weight (including 1S battery): 49-56g

Package Contents

  • 1 x Motor
  • 2 x 8mm screws for T mount props
  • 4 x 5mm screws
Width:
4.00 (cm)
Height:
2.00 (cm)
Depth:
4.00 (cm)
Stator Size:
13xx